Picking the appropriate frame design when setting up new windows in Leawood

Windows Replacement: Selecting the proper frame style


Last week, I informed you how to measure for your vinyl replacement windows when changing aluminum windows. Since you’re ready to get your brand-new vinyl replacement windows, we require to discuss the various frame design alternatives available. In a lot of the nation your choices are limited to either new building and construction or substitute frameworks. Brand-new building and construction structures feature a nailing fin to attach the frame to the studs throughout the building of the new house. The substitute frame is primarily the brand-new building frame minus the nailing fin.

But in the west, where stucco homes prevail, manufacturers created a 3rd sort of frame called a retrofit frame. The retrofit frame has a fin regarding 2 inches broad, located flush with the outdoors face of the home window. This is the most effective choice when changing old windows, but not all tasks will accommodate a retrofit frame application. So allow’s go over just how to determine which frame is most likely to help you.

If you have a stucco outside, retrofit is the means to go. You set up the new window from the outdoors, and the flush fin covers the old aluminum frame that you are going to leave in place. Then you screw the brand-new home window in operation deck screws through the side channels as well as the top header. We will certainly get into more detail on the real setup in a future write-up. If you have a stucco exterior, however there is a wood trim around the opening of the home window where the flush fin would typically go, you can still make use of the retrofit style frame. You would certainly require to remove the wood surrounding the opening, set up the retrofit home window, then purchase as well as install brand-new wood trim. The old trim will certainly no more fit because the retrofit window frame measurements will be larger in width and height than the old window frame. An additional option is to mount the retrofit fin in addition to the wood trim. You can do this as lengthy as the deepness from the face of the wood trim to the point in your house of the inner part of the old aluminum frame is much less than 3 inches deep. The factor is due to the fact that a high quality retrofit window will have a 3 inch frame depth from the rear of the flush fin to the inner part of the frame. That inner part requires to be even more into the house than the inner component of the aluminum frame to make sure that the aluminum frame will be hidden after we apply the inside trim. What if you have block around the window openings? Or exterior siding? After that what?

Well, if you can set up the home window versus the face of the brick or siding and also still have the innermost part of the vinyl frame be additionally into the house than the old frame, then you can use the retrofit style frame. If not, after that you need to use the replacement style frame, after that use trim to complete the outside. If you are able to get a retrofit frame with a reasonably thin fin, you can also trim the fins so the window fits in between the brick or wood. That would remove the demand to cut out the exterior. Some manufacturers of retrofit frames will certainly have grooves in the back of the retrofit fins. You just run an utility knife in the groove till you have the ability to break short that piece of the fin.

The main point to keep in mind when establishing whether or not to utilize a retrofit frame or a common substitute frame is that in order to make use of the retrofit frame there needs to be much less than 3 inches from the outside factor where the flush fin will rest to the within point in the space where the old frame ends. If it’s much less than 3 inches, go with the retro, greater than 3 inches, use the replacement frame and include trim to the outdoors instead of the flush fin.