Selecting the proper frame design when installing brand-new windows in Grandview - Roofing Contractor Overland ParkRoofing Contractor Overland Park

Selecting the proper frame design when installing brand-new windows in Grandview

Windows Replacement: Choosing the appropriate frame design


Last week, I told you just how to measure for your vinyl substitute windows when changing aluminum windows. Since you’re ready to purchase your new vinyl substitute windows, we require to discuss the different frame style choices readily available. In a lot of the country your options are limited to either brand-new building and construction or replacement frameworks. Brand-new construction frameworks come with a nailing fin to connect the frame to the studs throughout the building of the new residence. The substitute frame is essentially the new building and construction frame minus the nailing fin.

But in the west, where stucco residences are common, manufacturers came up with a third type of frame called a retrofit frame. The retrofit frame has a fin regarding 2 inches broad, located flush with the outdoors face of the window. This is the very best option when changing old windows, however not all tasks will accommodate a retrofit frame application. So let’s go over exactly how to identify which frame is most likely to help you.

If you have a stucco outside, retrofit is the method to go. You install the new home window from the outdoors, and also the flush fin covers the old aluminum frame that you are most likely to leave in position. After that you screw the brand-new home window in operation deck screws with the side channels along with the leading header. We will get into even more information on the actual installation in a future post. If you have a stucco exterior, yet there is a wood trim around the opening of the home window where the flush fin would usually go, you can still use the retrofit design frame. You would require to get rid of the wood bordering the opening, install the retrofit window, then purchase as well as mount brand-new wood trim. The old trim will certainly no longer fit given that the retrofit home window frame dimensions will be bigger in width and also elevation than the old window frame. One more option is to mount the retrofit fin in addition to the wood trim. You can do this as long as the deepness from the face of the wood trim to the factor in the house of the inner part of the old aluminum frame is less than 3 inches deep. The factor is due to the fact that a good quality retrofit home window will certainly have a 3 inch frame depth from the rear of the flush fin to the inner part of the frame. That innermost part needs to be additionally into your house than the inner part of the aluminum frame so that the aluminum frame will be hidden after we use the within trim. What happens if you have brick around the window openings? Or home siding? Then what?

Well, if you can mount the window against the face of the brick or siding and also still have the inner part of the vinyl frame be even more right into the residence than the old frame, after that you can make use of the retrofit style frame. Otherwise, then you need to use the substitute design frame, then use trim to end up the outside. If you are able to get a retrofit frame with a fairly slim fin, you can also bring down the fins so the window fits between the brick or wood. That would certainly remove the need to cut out the outside. Some manufacturers of retrofit frames will have grooves in the rear of the retrofit fins. You simply run an utility knife in the groove till you are able to break off that piece of the fin.

The main point to keep in mind when identifying whether or not to utilize a retrofit frame or a standard replacement frame is that in order to use the retrofit frame there requires to be much less than 3 inches from the outside factor where the flush fin will certainly rest to the inside factor in the area where the old frame ends. If it’s less than 3 inches, opt for the retro, greater than 3 inches, use the replacement frame and add trim to the outside in lieu of the flush fin.